2D Fabrication-Balancing Bird

 

This week, I cooperated with Camila, used laser cutter to finish our project.
I hope our project not only can stand up, but also be more interesting. I got the idea from the balancing bird toy. I draw the original design on procreate, however the proportion is incorrect. Camila finished the final design with Illustrator.
We used card board to test our design. We found it is not balancing perfectly. So we cut down the bottom part and the tail part, to make the body lighter. We taped card board on the wings, to make the wings heavier. The center of mass should be lower than the tip of beak. We changed our design.
Our final cutting didn't go very well, the wings part couldn't removed from the board. We tried box cutter and sand paper, but didn't work. So we had to remake the wings.
To be honest, this project took us some time and I was worried that we wouldn't be able to succeed. Fortunately, Camila is very patient and we did a very good team work. 





Comments

Popular posts from this blog

The Days Without Technology

Blank Assignment: Coding Agian

3D Print